ANT Forum

I am starting with Ant+ and try to read instead of ask here, but many general things are not obvious for me. I try to build Ant+ front light controller to connect to my Garmin Edge 1030. I have also nRF52810 board (not dev board). Questions:
1*. Is DAPLINK / JLINK OB suitable to flash SoftDevice S212 to my nRF ? I used it for another Cortex M0-M4 boards.

2*. I need to run my own, easy task between SoftDevice S212 stack and led lamp hardware.
I need 2-3x PWM outputs to drive led MOS transistors,
2x: ADC for battery voltage measurement and light sensor,
1x input I/O for a button
Can I write my own task and run on the same nRF52810(or 11) Soc TOGETHER with 212 Ant+ soft stack as a next task or should I do it on another micro controller connected with nRF (Tx,Rx connection)?

3* As far as understood current version of SimulAnt+ doesn`t support light profile. Am I right? Which one does?

Thank you in advance for your help.      

Yes, DAPLink and JLINK OB programmers are suitable for flashing the SoftDevice S212 onto your nRF52810. Both tools support programming Cortex-M devices, and as long as your nRF52810 board has the necessary SWD (Serial Wire Debug) interface available, you should be able to use either to flash the SoftDevice. You can check out survival race to know more information.