ANT Forum

Hi everyone,

im new with ANT and i´m not sure about what I will need to perform some tasks to my project. I´m reading and save some sensor values with my MCU PIC16 in the eeprom, and i want to send this data to the PC via wireless. I was thinking in buy a AT3 module to connect directly with my MCU PIC16, and send data to the usb stick. Is it possible to do that? (usb stick connected to the PC and AT3 module connected in a PCB board made by myself). I was thinking in send the serial data (which is stored in the MCU EEPROM) via MCU-ANT module using the I/O pins of the MCU (assinchronously).

regards,

David      

Hi,

It is strongly recommended that new ANT developers use the following two FAQ posts:

http://www.thisisant.com/component/option,com_fireboard/Itemid,146/func,view/catid,25/id,1391/

http://www.thisisant.com/component/option,com_fireboard/Itemid,146/func,view/catid,25/id,1169/      

Hi,

thanks for the reply

Is there any code example for Synchronous Messaging with Bit Flow Control using IO lines?

regards,

David      

Hi,

Please refer to 'Reference Design Examples' section in the forum post below:
http://www.thisisant.com/component/option,com_fireboard/Itemid,146/func,view/catid,25/id,1391/

There are ANT embedded reference designs that implement bit synchronous communication.      

Hi,

could you tell me what is the red light blinking in the AT3 module?
I can´t find this information anywhere...

regards,

David      

Please refer to the "ANT protocol and Usage" page54 Enable LED(0x68)for all the details:
http://www.thisisant.com/images/Resources/PDF/1204662412_ant message protocol and usage.pdf