ANT Forum

Hello,
i wan to ask regarding garmin bike speed and cadence, i doing application for cycling n i try to use ant+ demo code for garmin bike sensor. the ant+ demo does not detect the sensor.I already change sensor id but it doesnot change anytime.how to solve this problem? can u give me complete source code for bike speed and cadence?      

Hi!

The only code we have available is the code on the downloads page. Have you already tried connecting the bike speed and cadence device to the ANT+ Simulator and been able to receive data? Also, have you read and understood the Bike Speed and Cadence Device Profile (available on the documents tab of the downloads page)?

Be aware that there are different set ups for bike speed sensors, bike cadence sensors and combined bike speed and cadence sensors, and make sure you're looking for the right thing (explained in the device profile).

Hope that helps!      

I have the same problem in AntWare II.

The ANT+ USB Stick is saying its working and Antware recognises it.

I'm using the ANT+ Key : 0xB9, 0xA5, 0x21, 0xFB, 0xBD, 0x72, 0xC3, 0x45. Using the [Set Network Key] button on net #0.

On 'Channel 0' I'm using it as a 'Slave' and setting the following

Channel Period : 8118
Radio Frequency : 57
Tx Power : 3
Search Timeout : 10
Low Priority Search Timeout : 2

Device #: 0
Device Type: 123
Trans Type : 0
I've hit the [Set ID] button.

Pairing Checked.

But when I [AUTO OPEN], I get the following.

Channel Id Set: 0,123,0, pairing
Auto-Open Initiated...
> Opening Channel...
EVENT_RX_SEARCH_TIMEOUT_0x01
:: 40, 00-01-01
EVENT_CHANNEL_CLOSED_0x07
:: 40, 00-01-07



I      

Channel Period : 8086
Radio Frequency : 57
Tx Power : 3
Search Timeout : 10
Low Priority Search Timeout : 2

Device #: 0
Device Type: 121
Trans Type : 0