ANT Forum

For the CTF Power sensor.

When you send a calibration request to the SimulANT device, you only get 1 reply.
From what I understand, you should get 10sec of reply (40 replies without messages lost)

Is that true for all CTF sensor? I hope so because I only save the new offset when I receive at least 5 message. (I do an average on the first 5 message received)
I see that ANT verification tools reply correctly with 40 offset message, but SimulANT only reply with one message.

Thanks!      

Thanks for the reply harrison!
I guess it was normal, just want to point out for the future version of SimulANT+, a really nice tool for developers.

On another subject, I am trying to run the Continuous Scanning Mode demo, downloaded there:
http://www.thisisant.com/developer/ant/advanced-features#44_tab.

The Demo runs fine, but I can't pick any data in CSM, using 2 ANT key, one broadcasting, one on CSM trying to receive data.
See my last post here : http://www.thisisant.com/forum/viewthread/4617/

Would love if the demo could compile with VS2013.
Keep up the good work!