I'm using D52QD2M4IA-A, for my design with BLE. For the Hardware, I'm using Altium Software with the libraries provided in the
tech Resources Section of the website. I have few doubts regarding hardware design. How should the hardware be connected to the SWD interface?
Connector D52Q Module
SWDIO --- H201
RESET --- H202
Vcc --- H203
SWDCLK --- H205
1. What about the two GND pins, GND Detect and SWO on the SWD interface? Which pins should this be connected to the D52Q module?
2. Is it required to connect Antennas NFC1/2 ? If yes, what type of Antenna?
3. I'm using only onboard Acceleration sensor, No other IO, so, do I need to make other connections to the hardware? or are the above two connections sufficient?
Image Attachments
Click thumbnail to see full-size image
