Welcome Guest,Register Now
Log In

ANT Forum

Welcome guest, please Login or Register

   

RTS for D52 module

Rank

Total Posts: 3

Joined 2021-04-22

PM

Hello,
We are evaluating the D52 starter kit N52DK2,we met some communication problem for the UART.
We used USB interface board to connect D52 module,we found that if we disabled RTS,the ANT ware can't find the device.Is RTS necessary for the UART communication of ANT?
Another problem:we also use VCC/RXD/TXD/RTS/GND for the UART communication,RXD/TXD/RTS connection succeeded,BR1/BR2/BR3 connected to VCC,PORTSEL connected to GND,baud rate was 57600,we can find the USB but not found the ANT+ device.
Thanks for your reply.
     
Avatar
RankRankRankRank

Total Posts: 741

Joined 2012-09-14

PM

Hi,

RTS is required to know when it is safe to send messages to the module.

Are you using a 3rd party USB/UART chip or the USB interface board included with the development kit?      
Rank

Total Posts: 3

Joined 2021-04-22

PM

Hi,
I used the USB interface board included with the DK.      
Avatar
RankRankRankRank

Total Posts: 741

Joined 2012-09-14

PM

To clarify, are you using SimulANT+ or ANTware II to try and connect with an ANT+ device?

Using the USB IF, the modules should work with those apps out of the box assuming they haven't been reprogrammed. SimulANT+ will be able to connect with an ANT+ device automatically.      
Rank

Total Posts: 1

Joined 2022-05-18

PM

Harrison - 25 May 2021 09:25 AM
To clarify, are you using SimulANT+ or ANTware II to try and connect with an ANT+ device?

Using the USB IF, the modules should work with those apps out of the box assuming they haven't been reprogrammed. SimulANT+ will be able to connect with an ANT+ device automatically.


Thank you admin for the suggestion. Are you facing problems in writing your essay assignments? If yes, then you can visit https://www.topessaywriting.org/essays-for-sale here where you will find essay writer through which you can take help to complete your essay assignments.