ANT Forum

Hi all,
I have a problem with this module.
I make a software reset, then I configure it for receive data from sensors, and it works ok during 30 seconds with any sensor.
After that it sends me {A4, 01, 6F, 00} message and it stops working, and I need to reconfigure all sensors profiles.

I didn't find any timeout like this in any document of ant protocol.
I haven't any pin available to control the hardware reset pin, so the reset pin is not connected anywhere. Is that a problem?

Is there any solution for this problem, wich could be the cause?

thanks.

     

Sorry for the question is my fault,
I have a timeout in my microcontroller program and makes a glitch in power signal and resets the AP281.      

HI..i am a new user here. I am a new learner in Embedded system. Can you please share the all details of your system? What kind of hardware you are using and what are its specifications? Also can you please share your firmware details also?

pcba usa       [ Edited: 19 October 2016 03:47 PM by KellyTurci ]